Sometimes getting the U-Factor, SHGC and VT values right is not enough. Often, the installation of the window itself, i.e. the entire window assembly can have flaws. These flaws result in air leakage – one of the main obstacles in trying to achieve energy efficiency with the help of windows.
If your house is built on the Passivhaus principles; or you are looking at seriously reducing your HVAC requirements (and thus the bill) then air leakages through windows can punch a large through your plan. Some energy efficient windows specify the AL value (expressed in cubic feet of air passing through for every square foot of the window assembly) between 0-1. The lower the value, the lesser the leakage. The industry-accepted value is 0.30.
Another problem for insulation is condensation. If you live in cold areas, you’ve probably seem frost or dew on the edges of the windows. Looks quite ‘Christmassy’ but it only means that much more heating load. Condensation happens when inside warm air comes into contact with cold panes and glass, which essentially means your windows are not doing such a good job insulating.
With condensation and air leakage, there aren’t fixed ratings to go by. However, certain materials and window technologies work better. For example, if you’re opting for multiple pane windows, looks for stainless steel spacers, or thermally improved spacers made from silicon foam or butyl tape. These spacers might be more expensive, but they are better are insulating, sealing and thus preventing unwanted heat transfer, while at the same time allowing from seasonal expansions and contractions in panes. Similarly, opting for energy efficient windows with two or more panes or glazing reduces condensation even at indoor humidity levels of 45-60%. This is especially true of windows with argon/krypton glass filled windows.

Comments are closed.